Belt feeder


Place:

Narvik, Norway

Factory product:

Construction steel

Scope of supply:

Mechanical design, manufacturing, delivery and installation

Description:

This belt feeder was offered as a key project from designing to manufacturing and installation. Manufacturing process was done according to EN 1090 EXC2 standard. Steel surface prepared according P2 class and welded using MAG 135 process.

For surface treatment there were used combination of airless wet painting and hot dip galvanization. Belt feeder was assembled with all components in our assembly room. After delivery it was installed by ERCON staff on site. Product was tested by our inhouse quality inspector according NDT (non-destructive testing) requirements and customer requirements.